English
中文简体
FrançaisProduct Consultation
Your email address will not be published. Required fields are marked *
As an important part of modern bathrooms, shower heads play a key role in enhancing the bathroom experience. Although the installation process of shower heads is relatively simple, the control of details is essential to ensure their normal use.
Preparation phase
Before installing the shower head, sufficient preparation is essential.
Choose the right shower head: Users need to choose the right type of shower head according to their personal needs and the overall design of the bathroom. Common types of shower heads on the market include handheld, fixed and rain shower types. Make sure that the interface of the selected shower head is compatible with the existing water pipe system to avoid subsequent installation problems.
Tool preparation: The tools needed during the installation process include wrenches, screwdrivers, sealing tape (or raw tape), cleaning cloths and spirit levels. These tools will help ensure a smooth installation process.
Turn off the water source: Before starting the installation, be sure to turn off the main water source to prevent water leakage during the installation process. You can usually find a shut-off valve near the water meter to ensure that the water source is completely shut off.
Disassemble the old shower head
If the user needs to replace the old shower head, the steps to disassemble the old device are as follows:
Use a wrench to disassemble: Use a wrench to turn the connection nut of the old shower head counterclockwise to easily disassemble it. Be careful not to use excessive force to avoid damaging the water pipe or connector.
Clean the water pipe interface: After disassembly, check the water pipe interface, remove the old sealant and dirt, and ensure that the interface is smooth and clean. This process is crucial for the sealing of the new shower head.
Install a new shower head
The steps to install a new shower head are as follows:
Check the sealing ring: On the connection nut of the new shower head, check whether it is equipped with a sealing ring. If it is missing, it is recommended to wrap an appropriate amount of sealing tape on the thread to prevent water leakage.
Connect the shower head: Align the new shower head with the water pipe interface and turn the connection nut clockwise until it is tightened. Be careful not to use excessive force to avoid damaging the connection part.
Adjust the angle: For adjustable shower heads, users can adjust the angle and height of the shower head according to their personal preferences to ensure that it can provide the best spray effect when in use.
Inspection and testing
After installation, the last step to ensure the normal operation of the shower head is to conduct necessary inspections and tests:
Turn on the water source: Slowly turn on the main water source and observe whether there is any leakage. If a leak is found, turn off the water source immediately and check whether the connection is tight or the seal is in place.
Test the shower head: Turn on the shower switch, test whether the water flow is normal, and check whether the spray pattern is as expected. At the same time, pay attention to whether the water pressure is appropriate to ensure the comfort of the shower experience.
Check the water pipe: During the test, observe whether there is any leakage in the water pipe and the connection. After ensuring that everything is normal, it can be used later.
